Insulation in Parkland, FL
Cardinal Insulation is based in Boca Raton and runs crews west to Parkland. We upgrade hot attics in Heron Bay, Parkland Isles, CypressHead, Parkland Bay, North Springs, and Tall Pines.
Same crew, same-week inspections, no subcontractors. The heat gain in Parkland's large two-story golf-community homes is exactly what our insulation is built for.
Get Your Free Quote
Itemized pricing by zone, back to you within the hour. No call required.
Serving Parkland, Florida.
Parkland is Broward County's gated-estate city, where large homes and western acreage push attic loads higher than the coast. We insulate them with blown-in attic systems, spray foam, and radiant barriers across ZIPs 33067–33076.
Installed to the standards the government sets.
Every Cardinal blown-in install is specified to the guidance issued by the U.S. Department of Energy, ENERGY STAR, and the Florida Building Commission — the three bodies that define how a South Florida attic should be insulated. We don't guess at R-value. We install to code, document it, and prove it in thermal imaging.
R-30 to R-60 for South Florida attics
The DOE recommends R-30 to R-60 of attic insulation for homes in DOE Climate Zone 1 (South Florida), noting that proper insulation is one of the most cost-effective ways to improve energy efficiency and comfort. Cardinal blows to R-38 — the midpoint of the DOE's recommended range for our climate.
DOE — Blown-In & Loose-Fill InsulationUp to 15% savings on heating & cooling
ENERGY STAR recommends R-30 to R-60 for Florida attics and reports that sealing air leaks and adding insulation can save homeowners up to 15% on heating and cooling costs — and up to 37% when paired with a radiant barrier in South Florida's climate. Cardinal air-seals before every blow so insulation performs at its rated R-value.
ENERGY STAR — Seal & InsulateR-30 ceiling minimum in the Florida Building Code
The Florida Building Commission administers the Florida Building Code, which sets a minimum ceiling insulation value of R-30 for residential construction in South Florida. Cardinal installs to or above code on every job — and documents compliance with a depth-measurement and FLIR proof report before you pay the balance.
Florida Building Commission — FBCThe Cardinal standard exceeds all three.
We air-seal before we blow, install to R-38 (above the R-30 code floor), document depth at multiple points, and deliver a FLIR thermal proof report — so you can see the install meets DOE, ENERGY STAR, and Florida Building Code guidance before you ever pay the balance.
Licensed, rated, and code-compliant in Parkland.
Trust isn't a claim — it's documentation. Cardinal is a licensed and insured Florida contractor with a 5.0★ Google rating, a documented FLIR thermal proof report on every install, and full Florida Building Code compliance.
Licensed & Insured — Florida
Cardinal carries Florida contractor licensing and full insurance. Local tri-city crews, never subcontracted, with a lifetime workmanship warranty on every install we touch.
5.0★ on Google — 93 verified reviews
The tri-city's top Google rating. Reviews are the #1 map-pack ranking factor, and our customers document the work — before-and-after FLIR thermal proof on every job.
Florida Building Code Compliant
Every install is specified to the Florida Building Code and IECC Climate Zone 2A — R-30 ceiling minimums, air-leakage limits, and hot-humid moisture management. We document compliance on every job.
FLIR Thermal Proof Report
You see the seal before you pay. A certified thermal-imaging protocol images your attic and ceiling plane before and after install — documented proof, not a claim.
Documented, not promised. Cardinal installs to Florida Building Code minimums, documents depth and FLIR proof on every Parkland job, and backs every install with a lifetime workmanship warranty.
Read our Google reviewsProPink fiberglass, installed to manufacturer spec
Before-and-after infrared proof on every job
Local crews, never subcontracted
Transferable to the next owner
What we install in Parkland.
Blown-In Attic Insulation
Fiberglass or cellulose blown to a uniform R-38 depth across your attic floor — filling every gap batts miss. Most homes done in a day.
Learn moreSpray Foam Insulation
Closed-cell and open-cell spray foam that seals the attic, adds a moisture barrier, and brings attic temperatures within 8° of living space.
Learn moreInsulation Removal
Safe, dust-controlled removal of contaminated, compressed, or water-damaged attic insulation before we blow in fresh material.
Learn moreAir Sealing
We seal penetrations and leaks before insulating, so your insulation performs at its rated R-value instead of leaking conditioned air.
Learn moreNeighborhoods we serve in Parkland.
The climate math for Parkland.
Official NOAA normals, Florida Building Code, and U.S. Department of Energy guidance — the data behind every insulation spec we write for this city.
Code vs. Cardinal
We install to the DOE / ENERGY STAR recommendation — above Florida code — because the cooling load in Zone 1 makes the extra depth worth it.
Parkland's inland western Broward location removes the immediate coastal breeze, so attic peak temperatures run a few degrees higher than the beach cities — NOAA normals show summer highs near 91°F. IECC Zone 1 hot-humid. Florida Building Code requires R-30 in the ceiling; the DOE and ENERGY STAR recommend R-38 for the cooling-dominated load and the larger two-story golf-community homes common here.
Source station: Coral Springs / Parkland, FL (NOAA COOP 08-1906). Values are rounded from 1991–2020 U.S. Climate Normals and are representative of the station, not a single year.
Why Parkland homes lose energy.
These are the six failures we find most often in Parkland attics. Every one of them is measurable on a free FLIR inspection — no guesswork, no upsell.
What Parkland property owners get.
The same documented process on every Parkland install — whether it is a single attic top-up or a whole-home retrofit. Nothing below is optional.
- Free on-site inspection with photographs of existing conditions
- Written scope: material, R-value per inch, installed depth and square footage
- Air sealing before insulation, every time
- Baffles installed to protect soffit intake ventilation
- Attic hatch weatherstripped and insulated to match the assembly
- Depth rulers set as documented verification
- Floor protection, containment and a vacuumed work path
- Itemized invoice suitable for rebate and tax credit filing
Trusted across Parkland, neighborhood by neighborhood.
One local crew covering all of Parkland, with a 5.0★ rating on Google and verified work on streets you recognize.
- Owens Corning Certified Installer
- FLIR thermal proof report on every job
- Licensed & insured Florida contractor
From leak to lock in four moves.
Clinical, documented, and barrier-free. Every Cardinal install follows the same precision sequence — no guesswork, no subcontractors.
01 · Diagnose
FLIR infrared maps every leak and gap in your home's thermal envelope.
02 · Deploy
Closed-cell foam + radiant barrier installed to full R-value, no shortcuts.
03 · Verify
Post-install thermal proof report — you see the sealed shield, not just trust it.
04 · Guarantee
Lifetime workmanship warranty + documented energy savings.
Get a Parkland insulation quote.
Free, itemized by ZIP code, no obligation. Or call and talk to a local specialist — open 24/7.
The questions Boca, Delray & Boynton actually ask.
Pricing depends on your home's size and the scope of work. Blown-in attic top-ups are the most affordable option, while closed-cell spray foam costs more because it also acts as a moisture barrier. We give you an itemized quote by ZIP code — no phone tag — and most homeowners recover the cost in a few years on cooling savings.
Florida code calls for a minimum of R-30 in the ceiling. We blow to R-38 — above code — because South Florida's heat gain makes the extra depth worth it. We'll measure your existing depth for free and tell you exactly what you need.
Most blown-in attic top-ups are finished in a single day. Spray foam and larger whole-home retrofits can take one to two days. We protect your living space, clean up, and hand you a FLIR proof report before you pay the balance.
Yes. We serve all of Parkland — including Heron Bay, Parkland Isles, CypressHead, Parkland Bay, North Springs, and Tall Pines. Same local crew, same-week scheduling.
Yes. The instant quote by ZIP code is free with no obligation. If you want a FLIR thermal inspection, that's free too — we document every attic before we recommend anything.
Serving the Boca–Delray–Boynton corridor.
From the Boca inlet to Boynton's western estates — every hot zone below is a home we sealed this year. This is our local service area.
